Administrator Guide

6 BGP path attribute entrie(s) using 392 bytes of memory
6 BGP AS-PATH entrie(s) using 294 bytes of memory
6 BGP community entrie(s) using 234 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/Pfx
1109::33 18508 0 0 0 0 0 never Active
2222::220 18508 0 0 0 0 0 never Active
4000::33 18508 0 0 0 0 0 never Active
4000::60 18508 0 0 0 0 0 never Active
9000::4:2 18508 0 0 0 0 0 never Active
9000::5:2 1 35 32 0 0 0 00:16:42 0
9000::6:2 2 35 32 0 0 0 00:16:39 0
9000::7:2 3 35 32 0 0 0 00:16:41 0
9000::8:2 18508 35 32 0 0 0 00:16:42 0
9000::9:2 18508 44 19 0 0 0 00:16:41 0
9000::a:2 18508 35 32 0 0 0 00:16:43 0
9000::b:14 18508 29 29 0 0 0 00:13:01 0
Dell#
timers bgp
Allows you to adjust the BGP network timers for all neighbors.
C9000 Series
Syntax
timers bgp keepalive holdtimer
To return to the default values, use the no timers bgp command.
Parameters
keepalive Enter the time interval in seconds between which the software sends keepalive
messages. The range is 1 to 65535. The default is 60 seconds.
holdtimer Enter the time interval in seconds which the software waits since the last keepalive
message before declaring a BGP peer dead. The range is 3 to 65535. The default is 180
seconds.
Defaults
• keepalive = 60 seconds
• holdtimer = 180 seconds
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Related
Commands
neighbor timers – adjusts BGP timers for a specific peer or peer group.
476 Border Gateway Protocol