Administrator Guide
linecard Configure linecard
link-bundle-distribution Configure link-bundle
load-balance Global traffic load-balance configuration
logging Modify message logging facilities
mac Global MAC configuration subcommands
mac-address-table Mac Address Table Configuration Subcommands
management Create a management crypto or route, etc
monitor Monitor monitored ports
no Reset a command
ntp Configure NTP
openflow Configure OpenFlow instance
password-attributes Configure password attributes
policy-map-input Configure input QoS policy map
policy-map-output Configure output QoS policy map
port-channel Configure port-channel group parameters
privilege Command privilege parameters
protocol Select a protocol to configure
protocol-tunnel Configure protocol tunneling
qos-policy-input Configure input QoS policy
qos-policy-output Configure output QoS policy
qos-rate-adjust Configure the number of bytes added to each
frame for rate policing/shaping
radius-server Set up RADIUS server
redundancy Set up linecard redundancy configuration
reload-type Configure the reload type
rmon Configure RMON alarm/event tables
route-map Create route-map or enter route-map command
mode
router Enable a routing process
script Start or stop a script
service Service selected component
service-class Define service class to policy based QoS/
Routing mapping
sflow sFlow configuration
snmp Modify SNMP parameters
snmp-server Modify SNMP parameters
storm-control Configure storm-control
strict-priority Configure a Queue as a strict priority queue
switch Configure Script CPU and Memory Limits
mount Mount target directory
tacacs-server Set up TACACS+ server
uplink-state-group Uplink state group creation and
configurations
username Establish user name authentication
util-threshold Cpu or memory utilization configurations
virtual-ip Virtual IP address
vlan-stack Vlan-stack command
vlt Enable Virtual Link Trunk
wred-profile Create a WRED profile
When entering commands, you can take advantage of the following timesaving features:The shortcut key combinations at the command
line are as follows:
• The commands are not case-sensitive.
• You can enter partial (truncated) command keywords. For example, you can enter int ten 0/1 for the interface
tengigabitethernet 0/1 command.
• To complete keywords in commands, use the TAB key.
• To display the last enabled command, use the up Arrow key.
• Use either the Backspace key or Delete key to erase the previous character.
• To navigate left or right in the command line, use the left and right Arrow keys.
Key
Combination
Action
CNTL-A Moves the cursor to the beginning of the command line.
CNTL-B Moves the cursor back one character.
CNTL-D Deletes the character at the cursor.
48 CLI Basics