Administrator Guide

clear pfc counters
Clear the PFC TLV counters and PFC statistics on an interface or stack unit.
C9000 Series
Syntax
clear pfc counters [port-type slot/port | stack-unit {unit number | all } all
stack-ports all}] | interface {statistics}]
Parameters
port-type Enter the keywords port-type then the slot/port information.
stack-unit unit
number
Enter the keywords stack-unit then the stack-unit number to be cleared.
all stack-ports all Enter the keywords all stack-ports all to clear the counters on all interfaces.
statistics Enter the keyboard statistics to clear the hardware PFC counters.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON.
9.7(0.1) Introduced on the S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you do not use the statistics parameter, both hardware and DCBx counters clear.
dcb-input
To apply pause or flow control for specified priorities using a configure delay time, create a DCB input policy.
C9000 Series
Syntax
dcb-input policy-name
To delete the DCB input policy, use the no dcb-input command.
Parameters
policy-name Maximum: 32 alphanumeric characters.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
506 Data Center Bridging (DCB)