Administrator Guide

Example
(Summary)
Dell (conf-if-te-0/1)#show int te 0/1 pfc statistics
Interface TenGigabitEthernet 0/1
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
--------------------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
Example (port
range)
Dell#show interfaces tengigabitethernet 10/0-1 pfc statistics
Interface TenGigabitEthernet 10/0
Interface Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
--------------------------------------------------------------------------
Te 10/0 P0 0 0 0
Te 10/0 P1 0 0 0
Te 10/0 P2 0 0 0
Te 10/0 P3 0 0 0
Te 10/0 P4 0 0 0
Te 10/0 P5 0 0 0
Te 10/0 P6 0 0 0
Te 10/0 P7 0 0 0
Interface TenGigabitEthernet 10/1
Interface Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
------------------------------------------------------------------------
Te 10/1 P0 0 0 0
Te 10/1 P1 0 0 0
Te 10/1 P2 0 0 0
Te 10/1 P3 0 0 0
Te 10/1 P4 0 0 0
Te 10/1 P5 0 0 0
Te 10/1 P6 0 0 0
Te 10/1 P7 0 0 0
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
dcb-enable
Enable data center bridging.
C9000 Series
Syntax
dcb enable[pfc-queues 1|4]
To disable DCB, use the no dcb enable command.
Parameters
pfc-queues Enter the pfc-queue range. To disable DCB, use the no dcb enable command. The range
is from 1 or 2.
Defaults None
Command Modes CONFIGURATION
516 Data Center Bridging (DCB)