Administrator Guide

speed (Management interface)
Set the speed for the Management interface.
C9000 Series
Syntax
speed {10 | 100 | auto}
To return to the default setting, use the no speed {10 | 100} command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 10/100 Mb/s.
auto Enter the keyword auto to set the interface to auto-negotiate its speed.
Defaults auto
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related
Commands
• interface ManagementEthernet — configures the Management port on the system (either the Primary or
Standby RPM).
• management route — configures a static route that points to the Management interface or a forwarding
router.
switchport
Place an interface in Layer 2 mode.
C9000 Series
Syntax
switchport [backup interface {tengigabit slot/port | fortyGigE slot/port |
port-channel number}]
To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter the no switchport command.
If a switchport backup interface is configured, first remove the backup configuration. To remove a switchport
backup interface, enter the no switchport backup interface {tengigabit slot/port |
fortyGigE slot/port | port-channel number} command.
Parameters
backup interface Use this option to configure a redundant Layer 2 link without using Spanning Tree. The
keywords backup interface configures a backup port so that if the primary port
752 Interfaces