Administrator Guide

Related
Commands
show lacp — displays the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
C9000 Series
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {src-mac address dest-mac address {vlan vlanid |
ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port channel
to display flow information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
incoming-
interface interface
Enter the keywords incoming-interface then the interface type and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a Gigabit Ethernet interface, enter the keyword gigabitethernet then the
slot/port information.
• For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then
the peid/stack-unit/port-pipe id information.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
NOTE: The peGigE or peTenGigE option is available only when the extended
bridge feature is enabled.
source-ip address Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP address
format.
source-port
number
Enter the keywords source-port then the source port number. The range is from 1 to
65536. The default is None.
destination-port
number
Enter the keywords destination-port then the destination port number. The range
is from 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac then the MAC source address in the nn:nn:nn:nn:nn:nn
format.
destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
766 Interfaces