Administrator Guide
hg-link-bundle-monitor trigger-threshold
Specify the bandwidth-percentage threshold used in HiGig link-bundle monitoring to determine uneven traffic distribution and when an
alarm is generated.
C9000 Series
Syntax
hg-link-bundle-monitor trigger-threshold percentage
To restore the default value, use the no version of this command.
Parameters
percentage
Trigger threshold (in percentage of link-bundle bandwidth) at which an SNMP trap is
generated. Valid values are 1 to 90.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2.1.0 Introduced on the Z9500.
9.3.0.0 Introduced on the Z9000 platform.
Defaults The default trigger-threshold value is 60.
Usage Information The trigger-threshold of bandwidth usage, which determines when the calculation of link-bundle utilization is
performed, is set at 60 percent of the link-bundle bandwidth. When the total traffic use (mean) is below the
trigger-threshold percentage, unevenness in link-bundle traffic distribution is not reported. If traffic unevenness is
detected in three consecutive measurements, an alarm is issued. The time interval between measurements is
defined by the rate interval for HiGig link polling (default 15 seconds).
show hardware hg-stats
Display the traffic statistics from internal ports in a HiGig link bundle/port channel on a line-card or switch fabric module (SFM) NPU.
C9000 Series
Syntax
show hardware {sfm npu-id | linecard slot} hg-stats {port hg-port—number | unit
npu-id port hg-port—number}
Parameters
sfm
npu-id
Specify a switch SFM (spine) NPU by entering the keyword sfm and SFM NPU ID. Valid
SFM NPU IDs are 0 to 1.
linecard
slot
Specify a line-card (leaf) NPU by entering the keyword linecard and line-card slot.
Valid slot numbers are 0 to 11.
hg-stats {port
hg-
port-number
| unit
npu-id
port
hg-
port-number
}
Enter the keyword hg-stats to display HiGig port statistics.
For an SFM NPU HiGig link bundle, specify only a HiGig port number. Valid SFM hg-port-
number values are 1 to 33.
For a line-card NPU HiGig link bundle, specify an NPU ID and a HiGig port number. Line-
card NPUs range is 0. Line-card HiGig port numbers range from 27 to 32.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.3.0.0 Added support for the hg-stats option on the Z9000 platform.
770 Interfaces