Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
debug ip igmp
Enable debugging of IGMP packets.
C9000 Series
Syntax
debug ip igmp [group address | interface]
• To disable IGMP debugging, use the no debug ip igmp [group address | interface]
command.
• To disable all debugging, use the undebug all command.
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This command
displays packets for IGMP and IGMP snooping.
Internet Group Management Protocol (IGMP) 835