Administrator Guide
• show ip traffic
• show tcp statistics
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
C9000 Series
Syntax
arp [vrf vrf-name]ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf
vrf-name
Enter a VRF name to configure an ARP entry for that VRF. Use the VRF option after the
keyword arp to configure a static arp on that particular VRF.
ip-address
Enter an IP address in dotted decimal format.
mac-address
Enter a MAC address in nnnn.nnnn.nnnn format.
interface
Enter any of the following keywords and slot/port or number information:
• For the Management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then
the pe-id, stack-unit unit number, and port-ID. The pe-id range is 0–255; the stack-
unit unit number range is 0–7; and the port-id range is 0–48.
• For a port extender 10-Gigabit Ethernet interface, enter the keyword peTenGigE
then the pe-id / stack-unit / port-id information. The pe-id range is from 0 to 255;
the stack-unit unit-number range is from 0 to 7; and the port-id range is 25 to 28 or
49 to 52 depending on the PE.
Defaults Not configured.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.13.0.1P1 Introduced peTenGigE interface support on the C9010.
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
864 IPv4 Routing