Administrator Guide

CAUTION: Executing this command causes traffic disruption.
Related
Commands
show ip fib linecard — shows FIB entries on a specified stack-unit.
clear ip route
Clear one or all routes in the routing table.
C9000 Series
Syntax
clear ip route {* | ip-address mask}
Parameters
* Enter an asterisk (*) to clear all learned IP routes.
ip-address mask Enter a specific IP address and mask in dotted decimal format to clear that IP address
from the routing table.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Related
Commands
• ip route — assigns an IP route to the switch.
• show ip route — views the routing table
• show ip route summary — views a summary of the routing table.
clear ip traffic
Clear IP traffic statistics on the switch CPUs.
C9000 Series
Syntax
clear ip traffic {cp | rp}
Parameters
cp Clear ip traffic statistics on the Control Processor CPU.
rp Clear ip traffic statistics on the Route Processor CPU.
Command Modes EXEC Privilege
870 IPv4 Routing