Administrator Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Added the ingress-port parameter for the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information By default, the system distributes incoming traffic based on a hash algorithm using the following criteria:
IP source address
IP destination address
TCP/UDP source port
TCP/UDP destination port
Related
Commands
hash-algorithm ecmp — changes the hash algorithm across an ECMP.
management route
Configure a static route that points to the Management interface or a forwarding router.
C9000 Series
Syntax
management route {{ip-address mask | {ipv6-address prefix-length}} {forwarding-
router-address | managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet}}
To remove a static route, use the no management route{{ip-address mask | {ipv6-address
prefix-length}}{forwarding-router-address | managementethernet | fortyGigE |
vlan | gigabitethernet | tengigabitethernet}} command.
Parameters
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix format) of the destination
subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the destination
subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in
the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format) of a
forwarding router.
managementether
net
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
fortyGigE Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
vlan Enter the keyword vlan to specify a vlan interface.
gigbitethernet Enter the keyword gigabitethernet to specify a one Gigabit Ethernet interface.
tengigabitetherne
t
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
IPv4 Routing 891