Reference Guide

isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
C9000 Series
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
isis password
Configure an authentication password for an interface.
C9000 Series
Syntax
isis password [hmac-md5] password [level-1 | level-2]
To delete a password, use the no isis password [password] [level-1 |
level-2] command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the password using DES.
hmac-md5 (OPTIONAL) Enter the keywords hmac-md5 to encrypt the
password using MD5.
password Assign the interface authentication password.
1014
Intermediate System to Intermediate System (IS-IS)