Reference Guide

To return to the default value, use the no ip igmp snooping last-member-
query-interval command.
Parameters
milliseconds Enter the interval in milliseconds. The range is from 100 to
65535. The default is 1000 milliseconds.
Defaults 1000 milliseconds
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
The last-member-query-interval is also the interval between successive Group-
Specific Query messages. The ip igmp snooping last-member-query-
interval command allows you to change the last-member-query interval.
ip igmp snooping mrouter
Statically configure a VLAN member port as a multicast router interface.
C9000 Series
Syntax
ip igmp snooping mrouter interface interface
To delete a specific multicast router interface, use the no igmp snooping
mrouter interface interface command.
Parameters
interface interface Enter the following keywords and slot/port or number
information:
1076
Internet Group Management Protocol (IGMP)