Reference Guide

rp Enter the keyword rp1 to view TCP statistics only from the
Route Processor.
Command Modes EXEC Privilege
Default Display TCP information from all processors.
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
6.4.1.0 Introduced
Usage Information The following describes the show tcp statistics cp command shown in the
following example.
Field Description
Rcvd: Displays the number and types of TCP packets received by
the switch.
• Total = total packets received
• no port = number of packets received with no
designated port
0 checksum
error...
Displays the number of packets received with the following:
• checksum errors
• bad offset to data
• too short
329 packets... Displays the number of packets and bytes received in
sequence.
17 dup... Displays the number of duplicate packets and bytes
received.
0 partially... Displays the number of partially duplicated packets and
bytes received.
1156
IPv4 Routing