Reference Guide

ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets generated and sent in one second.
C9000 Series
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-
rate-limit command.
Parameters
pps Enter the maximum number of error packets generated per
second. The range is from 1 to 200.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
C9000 Series
Syntax
ipv6 flowlabel-zero
To remove 0 from the flow label field and allow the protocol operations to fill the
field, use the no ipv6 flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
1190
IPv6 Basics