Reference Guide

disable Enter the keyword disable to disable the application of
preferential QoS treatment to iSCSI frames.
dot1p vlan-
priority-value
Enter the dot1p value of the VLAN priority tag assigned to
the incoming packets in an iSCSI session. The range is from
0 to 7. The default is the dot1p value in ingress iSCSI frames
is not changed and is the same priority is used in iSCSI TLV
advertisements if you did not enter the iscsi priority-
bits command.
dscp dscp-value Enter the DSCP value assigned to the incoming packets in
an iSCSI session. The valid range is from 0 to 63. The default
is: the DSCP value in ingress packets is not changed.
remark Marks the incoming iSCSI packets with the configured dot1p
or DSCP value when they egress to the switch. The default
is: the dot1and DSCP values in egress packets are not
changed.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Introduced on the Z9500.
Usage Information By default, iSCSI flows are assigned to dot1p priority 4.
iscsi enable
Globally enable iSCSI optimization.
C9000 Series
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
iSCSI Optimization
1215