Reference Guide

Multicast

The multicast commands are supported by Dell Networking operating system.

This chapter contains the following sections:

• IPv4 Multicast Commands

• IPv6 Multicast Commands

IPv4 Multicast Commands

The following section contains the IPv4 multicast commands.

clear ip mroute

Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent

multicast (PIM) tree information base, use the

clear ip pim tib command.

C9000 Series

Syntax

clear ip mroute {group-address [source-address] | * | snooping}

Parameters

group-address

[source-address]

Enter the multicast group address and source address (if

desired), in dotted decimal format, to clear information on a

specific group.

* Enter * to clear all multicast routes.

snooping Enter the keyword snooping to delete multicast snooping

route table entries.

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2.(0.0) Added support for keyword snooping on the Z9000,

S4810, and S4820T.

Multicast

1301