Reference Guide

address in dotted decimal format (A.B.C.D) to limit the
information displayed to the multicast routes for a specified
multicast group and optionally a source multicast address in
dotted decimal format (A.B.C.D) to limit the information
displayed for a specified multicast source. Enter the
keyword count to display the total number of multicast
routes with the spanned IIF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for keyword vlt to the Z9000, S4810, and
S4820T.
8.4.1.1 Support for the keyword snooping and the optional vlan
vlan-id, group-address, and source-address
parameters were added on E-Series ExaScale.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Example (Static)
Dell#show ip mroute static
Mroute: 23.23.23.0/24, interface: Lo 2
Protocol: static, distance: 0, route-map: none, last change:
00:00:23
Example
(Snooping)
Dell#show ip mroute snooping
IPv4 Multicast Snooping Table
(*, 224.0.0.0), uptime 17:46:23
Incoming vlan: Vlan 2
Outgoing interface list:
GigabitEthernet 4/13
(*, 225.1.2.1), uptime 00:04:16
1306
Multicast