Reference Guide

Version Description
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
device-role
Specify the role of the device attached to the port.
C9000 Series
Syntax
device-role {host | router}
To reset the device role, use the no device-role {host | router}
command.
Parameters
host Enter the keyword host to set the device-role as host.
router Enter the keyword router to set the device-role as router.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9.(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and
enter the RA guard policy configuration mode.
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
hop-limit
Enable the verification of the advertised hop count limit. If this command is not configured, the
verification process is bypassed.
C9000 Series
Syntax
hop-limit {maximum | minimum limit}
1350
Neighbor Discovery Protocol (NDP)