Reference Guide

To reset the hop count limit, use the no hop-limit {maximum | minimum
limit} command.
Parameters
maximum limit Enter the keyword maximum then the hop limit value. The
range is from 0 to 254.
minimum limit Enter the keyword minimum then the hop limit value. The
range is from 0 to 254.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable—Allows you to configure the RA guard related
commands.
• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and
enter the RA guard policy configuration mode.
ipv6 nd ra-guard attach-policy
Apply the IPv6 RA guard to a specific interface.
C9000 Series
Syntax
ipv6 nd ra-guard attach—policy policy-name [vlan [vlan 1, vlan
2, vlan 3.....]]
Parameters
policy policy-
name
Enter the keyword policy then the policy name. The
policy-name allows a maximum of 140 characters.
vlan [vlan 1, vlan 2,
vlan 3........]
Enter the keyword vlan then the VLAN range. The VLAN
range is from 1 to 4094.
Defaults none
Command Modes INTERFACE
Neighbor Discovery Protocol (NDP)
1351