Reference Guide

mtu
Enable the verification of the configured maximum transmission unit (MTU) value in the received RA
packets.
C9000 Series
Syntax
mtu value
To reset the MTU value, use the no mtu value command.
Parameters
value Enter the maximum transmission unit value in bytes. The
range is from 1,280 to 11,982 bytes.
Defaults 0
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and
enter the RA guard policy configuration mode.
other-config-flag
Enable the verification of the advertised other configuration parameter. If this command is not
configured, the verification process is bypassed.
C9000 Series
Syntax
other-config-flag {on | off}
To reset the other configuration parameter, use the no other-config-flag
{on | off} command.
Parameters
on Enter the keyword on to set the other-config-flag value as
ON.
Neighbor Discovery Protocol (NDP)
1357