Reference Guide
36
Object Tracking
Object Tracking supports IPv4 and IPv6 protocols.
Object tracking allows you to define objects of interest, monitor their state, and report to a client when a
change in an object’s state occurs. The following tracked objects are supported:
• Link status of Layer 2 interfaces
• Routing status of Layer 3 interfaces (IPv4 and IPv6)
• Reachability of IPv4 and IPv6 routes
• Metric thresholds of IPv4 and IPv6 routes
You can configure client applications, such virtual router redundancy protocol (VRRP), to receive a
notification when the state of a tracked object changes.
This chapter contains the following sections:
• IPv4 Object Tracking Commands
• IPv6 Object Tracking Commands
IPv4 Object Tracking Commands
The following section describes the IPv4 object tracking commands.
debug track
Enable debugging for tracked objects.
C9000 Series
Syntax
debug track [all | notifications | object-id]
Parameters
all Enables debugging on the state and notifications of all
tracked objects.
notifications Enables debugging on the notifications of all tracked
objects.
object-id Enables debugging on the state and notifications of the
specified tracked object. The range is from 1 to 500.
Defaults Enable debugging on the state and notifications of all tracked objects (debug
track all).
Object Tracking
1367