Reference Guide

OSPFv2 Commands
The Dell Networking implementation of OSPFv2 is based on IETF RFC 2328. .
area default-cost
Set the metric for the summary default route the area border router (ABR) generates into the stub area.
Use this command on the border routers at the edge of a stub area.
C9000 Series
Syntax
area area-id default-cost cost
To return default values, use the no area area-id default-cost command.
Parameters
area-id Specify the OSPF area in dotted decimal format (A.B.C.D.) or
enter a number from zero (0) to 65535.
cost Specifies the stub area’s advertised external route metric.
The range is from zero (0) to 65535.
Defaults cost = 1; no areas are configured.
Command Modes ROUTER OSPF
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for the Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information In the Dell Networking operating software, cost is defined as reference
bandwidth/bandwidth.
Related
Commands
area stub — creates a stub area.
Open Shortest Path First (OSPFv2 and OSPFv3)
1391