Reference Guide

reset
Reset or reboot the linecard, RPM, PE and PE stack-unit.
C9000 Series
Syntax
reset {linecard slot-id | rpm slot id [hard] | pe pe-id [stack-unit
unit-number]}
From a PE console, use reset stack-unit unit-number [hard] to reset the stack-unit.
Parameters
linecard slot-id Enter the keyword linecard and the slot-id number to specify the set
of line-card ports for reset. The slot ID range is from 0 to 11.
rpm Enter the keyword rpm and the slot-id number to specify the route
processor module (RPM) ports for reset. The range for the RPM card
ports is from 0 to 1.
hard (Optional) Reboot (power cycle) the specified line card, RPM card, or PE
stack-unit (The hard option for PE is only available from PE console).
pe pe-id Enter the keyword pe and the port extender (PE) ID. The range for pe-id
is from 0 to 255.
stack-unit unit-
number
(Optional) Enter the keyword stack-unit and the stack-unit number.
The range is from 0 to 7.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.3.1.0 Added the hard reset option.
7.8.1.0 Augmented to run on the standby unit in order to reset the standby unit
directly.
7.7.1.0 Introduced on the S-Series.
PE Stacking
1531