Reference Guide

ip pim bsr-candidate
To join the Bootstrap election process, configure the PIM router.
C9000 Series
Syntax
ip pim bsr-candidate interface [vrf vrf-name][hash-mask-length]
[priority]
To return to the default value, use the no ip pim bsr-candidate [vrf vrf-
name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name
of the VRF to configure the PIM router on a VRF.
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
hash-mask-length (OPTIONAL) Enter the hash mask length. The range is from
zero (0) to 32. The default is 30.
priority (OPTIONAL) Enter the priority used in Bootstrap election
process. The range is from zero (0) to 255. The default is
zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
PIM-Sparse Mode (PIM-SM)
1575