Reference Guide

seq
Configure a filter with an assigned sequence number for the redirect list.
C9000 Series
Syntax
seq sequence-number {permit | redirect {ip-address | tunnel
tunnel-id}[track <obj-id>] }} {ip-protocol-number | protocol-
type} {source mask | any | host ip-address} {destination mask |
any | host ip-address} [bit] [operator]{source-port source-
port| source-port-range start-port - end-port} {destination-
port destination-port| destination-port-range start-port - end-
port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the keyword IP address of the forwarding router.
tunnel Enter the keyword tunnel to configure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-
number
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to
the filter.
Policy-based Routing (PBR)
1609