Reference Guide

Usage Information
You can connect to an attached PE through Telnet using the connect pe
command and view information specific to the PE system. After you log in to a port
extender, enter ? or help to display a list of supported commands.
Example
Dell#connect pe 254
Login: peadmin
Password:
DellPE>
feature extended-bridge
Enable 802.1BR (bridge port extender) support on the switch.
C9000 Series
Syntax
[no] feature extended-bridge
To disable 802.1BR support on the switch, use the no feature extended-
bridge command.
Default None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
This command enables support for the 802.1 bridge PE (BR) on your switch.
Enabling the PE feature allows you to provision the PE. The no feature
extended-bridge command disables bridge PE support and deprovisions a PE.
You can verify the extended-bridge feature is enabled using the
show feature
command. The following example shows the extended-bridge feature is enabled.
Example
Dell>show feature
Feature State
------- -----
VRF disabled
Extended-Bridge enabled
Related
Commands
pe provision — Logically provision or add a PE.
1616
Port Extenders (PE)