Reference Guide

MACMGR 96 1 0 0 0 0 0 0 0
DSAGT 108 1 0 0 0 0 0 0 0
IFMGR 138 1 0 0 0 0 0 0 0
MRTM 139 1 0 0 0 0 0 0 0
L2AGENT 144 1 0 0 0 0 0 0 0
PORTMIRR 191 1 0 0 0 0 0 0 0
SFL_LP 194 1 0 0 0 0 0 0 0
SFL_CP 195 1 0 0 0 0 0 0 0
POEMGR 251 1 0 0 0 0 0 0 0
Power over Ethernet (PoE)
Use the commands in this section to configure the Power over Ethernet (PoE) feature on a C1048P port-
extender (PE). PoE is not supported on C9010 switches. To manage PoE on port-extender ports, the
C1048P uses two types of power supplies: the main internal, fixed AC power supply and an external DC
power supply. Each power supply provides 1000W, of which up to 850W is used for PoE. For information
about using the PoE stacking feature, refer to the “Power over Ethernet (PoE)” chapter in the Dell
Networking OS Configuration Guide for the C9000 Series. The following PoE commands are supported
on the Dell Networking OS.
advertise dot3-tlv
Configure the system or an interface to advertise IEEE 802.3at extended power-via-mdi.
C9000 Series
Syntax
advertise dot3-tlv power-via-mdi
To remove the advertised dot3–tlv, use the no advertise dot3–tlv power-
via-mdi command
Parameters
power-via-mdi Enter the keyword power—via-mdi to advertise IEEE
802.3at power-via-mdi TLV.
Defaults Disabled
Command Modes
• LLDP CONFIGURATION (conf-lldp)
• INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Port Extenders (PE)
1643