Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The advertise dot3–tlv power—via—mdi command enables the system to
advertise IEEE 802.3at power-via-mdi TLV to advertise its power negotiation
capabilities with the powered devices via Link Layer Discovery Protocol (LLDP). You
can configure this command either on a specific interface or globally.
Example
Dell(conf)#interface peGigE 0/0/0
Dell(conf-if-pegi-0/0/0)#protocol lldp
Dell(conf-if-pegi-0/0/0-lldp)#advertise dot3-tlv power-via-mdi
Dell(conf-if-pegi-0/0/0-lldp)#
advertise med power-via-mdi
Configure the system to advertise IEEE 802.1ab extended power-via— MDI TLV.
C9000 Series
Syntax
[no] advertise med power-via-mdi
To return to the default, use the no advertise med power-via-mdi command.
Parameters
power-via-mdi Enter the keyword power—via-mdi to advertise IEEE
802.1ab MED Extended power-via-mdi TLV.
Defaults Disabled
Command Modes
• LLDP CONFIGURATION (conf-lldp)
• INTERFACE LLDP CONFIGURATION (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
Advertise extended power via MDI TLVs to all ports that are connected to the
802.1ab powered endpoint devices.
When the advertise med power-via-mdi command is enabled in
CONFIGURATION mode, advertisement is enabled for all the interfaces in a system.
1644
Port Extenders (PE)