Reference Guide

To enable advertisement for a specific interface, configure the command in
INTERFACE configuration mode.
Port extender (PE) processes and advertises LLDP power-via-MDI TLVs when the
LLDP advertisement of the TLV is enabled on the PE in class power management
mode. Incoming LLDP messages are processed only when the PE is in class power
management mode.
on-disable
Enable transmission of LLDP shutdown frames.
C9000 Series
Syntax
on-disable transmit {shutdown}
Parameters
transmit Enter the keyword transmit to transmits the LLDP frames.
shutdown Enter the keyword shutdown to shut down the LLDP
frames.
Defaults None.
Command Modes CONFIGURATION INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The on-disable transmit shutdown command allows transmission of LLDP
shutdown frames when the LLDP protocol is disabled in the interface mode.
Example
Dell#sh running-config interface tengigabitethernet 0/1
!
interface TenGigabitEthernet 10/1
no ip address
switchport
switchport mode private-vlan host
!
protocol lldp
on-disable transmit shutdown
no shutdown
Related
Commands
show running-config lldp — displays the LLDP running configuration.
Port Extenders (PE)
1645