Reference Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Policy name character limit increased from 16 to 32.
7.6.1.0 Introduced on the C-Series and S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
To specify the name of the input QoS policy, use this command. After the input
policy is specified, rate-police is defined. This command enables Qos-Policy-Input
Configuration mode — (conf-qos-policy-in).
When changing a Service-Queue configuration in a QoS policy map, all QoS rules
are deleted and re-added automatically to ensure that the order of the rules is
maintained. As a result, the Matched Packets value shown in the show qos
statistics
command is reset.
If you create create a QoS input policy to be used for CoPP, you must enter the
keyword cpu-qos.
Related
Commands
rate police — incoming traffic policing function.
qos-policy-output
Create a QoS output policy.
C9000 Series
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Quality of Service (QoS)
1705