Reference Guide

show config
Display the changes you made to the RIP configuration. The default values are not shown.
C9000 Series
Syntax
show config
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 0/1
Dell(conf-router_rip)#
show ip rip database
Display the routes that RIP learns. If the switch learned no RIP routes, no output is generated.
C9000 Series
Syntax
show ip rip database [ip-address mask]
Parameters
ip-address (OPTIONAL) Specify an IP address in dotted decimal format
to view RIP information on that network only. If you enter
an IP address, also enter a mask for that IP address.
Routing Information Protocol (RIP)
1789