Reference Guide

upload trace-log
Upload a trace log file from a switch CPU.
C9000 Series
Syntax
upload trace-log {cp [cmd-history]| linecard | slot-id | pe pe-
id [stack-unit unit number ] |rp } [sw-trace | hw-trace]
Parameters
rp Enter the keyword rp to upload a trace log from the Route
Processor.
cp Enter the keyword cp to upload a trace log from the Control
Processor.
linecard slot-id Enter the linecard slot-id parameters to specify the
line-card CPU whose trace log you want to upload.
cmd-history Enter the keyword cmd-history to upload the command
history from the specified CPU.
hw-trace Enter the keyword hw-trace to upload the hardware trace
log from the specified CPU.
sw-trace Enter the keyword sw-trace to upload the software trace
log from the specified CPU.
pe pe-id Enter the keyword pe and port extender ID. Range is from 0
to 255.
NOTE: The pe option is only available when the
extended bridge feature is enabled.
stack unit number Enter the keyword stack unit and a stack unit number.
Stack unit range is from 0 to 7.
Defaults None.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.1.1.0 Introduced on the E-Series ExaScale.
7.5.1.0 Introduced on the C-Series.
Usage Information Trace log information is uploaded to flash:/TRACE_LOG_DIR.
Control and Monitoring
179