Reference Guide

Parameters
default Enter the keyword default then the authentication
methods to use as the default sequence of methods for the
Enable login. The default is default enable.
method-list-name Enter a text string (up to 16 characters long) to name the list
of enabled authentication methods activated at login.
method Enter one of the following methods:
• enable: use the password the enable password
command defines in CONFIGURATION mode.
• line: use the password the password command
defines in LINE mode.
• none: no authentication.
• radius: use the RADIUS servers configured with the
radius-server host command.
• tacacs+: use the TACACS+ server(s) configured with
the tacacs-server host command.
... method2 (OPTIONAL) In the event of a “no response” from the first
method, the system applies the next configured method.
Defaults Use the enable password.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.0 Introduced on the E-Series.
Usage Information
By default, the Enable password is used. If you configure aaa authentication
enable default, the system uses the methods defined for Enable access
instead.
1812
Security