Reference Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1841

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the C-Series and S-Series.

7.4.1.0 Introduced on the E-Series.

Commands

dot1x authentication (Configuration) — enables dot1x globally.

dot1x auth-fail-vlan

Configure an authentication failure VLAN for users and devices that fail 802.1X authentication.

C9000 Series

Syntax

dot1x auth-fail-vlan vlan-id [max-attempts number]

To delete the authentication failure VLAN, use the no dot1x auth-fail-vlan

vlan-id [max-attempts number] command.

Parameters

vlan-id Enter the VLAN Identifier. The range is from 1 to 4094.

max-attempts

number

(OPTIONAL) Enter the keywords max-attempts then

number of attempts desired before authentication fails. The

range is from 1 to 5. The default is 3.

Defaults 3 attempts

Command Modes CONFIGURATION (conf-if-interface-slot/port)

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.