Reference Guide

Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command changes the sampling rate for an interface. By default, the sampling
rate of an interface is set to the same value as the current global default sampling
rate if port is operationally down, otherwise sampling rate changes based on port
line speed. If the value entered is not a correct power of 2, the command
generates an error message with the previous and next power-of-2 value. Select
one of these two number and re-enter the command.
Related
Commands
sflow sample-rate (Global) — changes the sampling rate globally.
show sflow
Display the current sFlow configuration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information.
• For a port channel interface, enter the keywords port-
channel
then a number.
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
sFlow
1905