Reference Guide

show logging kernellog
Display the kernel log for the specified hardware component.
C9000 Series
Syntax
show logging kernellog {cp | rp | linecard slot-id | pe pe-id
stack unit unit-number}
From a PE console, use show logging kernellog stack-unit unit number
to display the kernel logging information for a specified stack-unit.
Parameters
cp Enter the keyword cp to display the kernel log for the
Control Processor on the switch.
rp Enter the keyword cp to display the kernel log for the Route
Processor on the switch.
linecard slot-id Enter the linecard slot-id parameters to specify the
line-card ports for which you want to display the kernel log.
The range of line-card slot IDs is from 0 to 2.
pe pe-id Enter the keyword pe and the port extender the ID to
display the kernel log for the specified port extender. The PE
ID range is from 0 to 255.
stack unit unit
number
Enter keyword stack-unit and the stack-unit number to
display the kernel log for the specified stack unit. Stack-unit
number range is from 0 to 7.
defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010 and C1048P.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
Simple Network Management Protocol (SNMP) and Syslog
1961