Reference Guide

Version Description
6.2.1.1 Introduced on the E-Series.
Usage Information When you enable debug spanning-tree bpdu for multiple interfaces, the
software only sends information on BPDUs for the last interface specified.
Related
Commands
protocol spanning-tree — enters SPANNING TREE mode on the switch.
description
Enter a description of the spanning tree.
C9000 Series
Syntax
description {description}
To remove the description from the spanning tree, use the no description
{description} command.
Parameters
description Enter a description to identify the spanning tree (80
characters maximum).
Defaults none
Command Modes SPANNING TREE (The prompt is “config-stp”.)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced
Related
Commands
protocol spanning-tree — enters SPANNING TREE mode on the switch.
Spanning Tree Protocol (STP)
1975