Reference Guide

ManualsBrandsDell ManualsAccess PlatformsC9010 Modular Chassis Switch

1991

To disable storm-control for multicast traffic into the network, use the no storm-

control multicast packets_per_second in command.

Parameters

packets_per_seco

nd in

Enter the packets per second of multicast traffic allowed

into the network. The range is from 0 to 33554368.

Defaults none

Command Modes CONFIGURATION (conf)

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.6.1.0 Introduced on the C-series and S-Series.

Usage Information Broadcast traffic (all 0xFs) should be counted against the broadcast storm control

meter, not against the multicast storm control meter. It is possible, however, that

some multicast control traffic may get dropped when storm control thresholds are

exceeded.

storm-control multicast (Interface)

Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only)

network only.

C9000 Series

Syntax

storm-control multicast packets_per_second in

To disable multicast storm control on the interface, use the no storm-control

multicast packets_per_second in command.