Reference Guide

• If Tunnel mode is ipv6ip (where ip address over tunnel interface is not possible).
To ping the unnumbered tunnels, the logical address route information must be
present at both the ends.
NOTE: The ipv6 unnumbered command can specify an interface name that
does not exist or does not have a configured IPv6 address. The tunnel
interface is not changed to operationally up until the logical ip address is
identified from one of the address family.
tunnel allow-remote
Configure an IPv4 or IPv6 address or prefix whose tunneled packets are accepted for decapsulation. If
you do not configure allow-remote entries, tunneled packets from any remote peer address is accepted.
This feature is supported on Dell Networking OS.
C9000 Series
Syntax tunnel allow-remote {ip-address | ipv6-address} [mask]
To delete a configured allow-remote entry use the no tunnel allow-remote
command. Any specified address/mask values must match an existing entry for the
delete to succeed. If the address and mask are not specified, this command deletes
all allow-remote entries.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D to match a range of remote addresses. The default
mask is /32 for IPv4 addresses and /128 for IPv6 addresses,
which match only the specified address.
Defaults If you do not configure tunnel allow remote , all traffic which is destined to tunnel
source address is decapsulated.
Command Modes INTERFACE TUNNEL
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000 and Z9000.
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
2022
Tunneling Commands