Reference Guide

Parameters
seconds Enter the number of seconds for the delay. The range is
from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
This command applies to all the VRRP configured interfaces on a system. When
used with the vrrp delay minimum CLI, the later timer rules the VRRP enabling.
For example, if vrrp delay reload is 600 and the vrrp delay minimum is
300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
Save the configuration and reload the system for the delay timers to take effect.
Related Command vrrp delay minimum — sets the delay time for VRRP initialization after a line card
reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 255 VRRP groups per interface.
C9000 Series
Syntax
vrrp-group vrrp-id
Parameters
vrrp-id Enter a number as the group ID. The range is from 1 to 255.
Defaults Not configured.
Command Modes INTERFACE
2088
Virtual Router Redundancy Protocol (VRRP)