Reference Guide

• For a 40-Gigabit Ethernet interface, enter the keyword
FortyGigE followed by the slot/port information.
• For a tunnel interface, enter the keyword tunnel
followed by the slot/port information.
• For a VLAN interface, enter the keyword vlan followed
by the VLAN ID. The VLAN ID range is from 1 to 4094.
• For a port extender (PE) Gigabit Ethernet interface, enter
the keyword peGigE followed by the pe-id /stack-unit
unit number / port-ID number.
priority-cost (OPTIONAL) Enter a number as the amount to be subtracted
from the priority value. The range is 1 to 254. The default is
10.
Defaults priority cost = 10
Command Modes VRRP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2.(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information If the interface is disabled, the cost value is subtracted from the priority value and
forces a new MASTER election if the priority value is lower than the priority value in
the BACKUP virtual routers.
IPv6 VRRP Commands
The following are IPv6 VRRP commands.
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
2090
Virtual Router Redundancy Protocol (VRRP)