Reference Guide

debug vrrp ipv6
Enable debugging of VRRP.
C9000 Series
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state |
timer}
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP
group ID.
all Enter the keyword all to enable debugging of all VRRP
groups.
bfd Enter the keyword bfd to enable debugging of all VFFP BFD
interactions.
database Enter the keyword database to display changes related to
group, prefix, and interface entries in the VRRP table.
packets Enter the keyword packets to enable debugging of VRRP
control packets.
state Enter the keyword state to enable debugging of VRRP
state changes
timer Enter the keyword timer to enable debugging of the VRRP
timer.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
2092
Virtual Router Redundancy Protocol (VRRP)