Reference Guide

You may specify both bytes of the 2-byte S-Tag TPID. The

range is from 0 to FFFF. The default is 9100.

Defaults 0x9100

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.2(1.0) Introduced on the Z9500.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Introduced on the E-Series ExaScale. C-Series and S-Series

accept both bytes of the 2-byte S-Tag TPID.

8.2.1.0 Introduced on the E-Series ExaScale.

7.6.1.0 Introduced on the C-Series and S-Series.

Usage Information

For specific interoperability limitations regarding the S-Tag TPID, see the Dell

Networking OS Configuration Guide.

The four characters you enter in the CLI for number are interpreted, as shown in

the following table.

Number Resulting TPID

1 0x0001

10 0x0010

81 0x0081

8100 0x8100

Commands

• portmode hybrid — sets a port (physical ports only) to accept both tagged and

untagged frames. A port configured this way is identified as a hybrid port in

report displays.

• vlan-stack trunk — specifies a Layer 2 port or port channel as a trunk port to the

Stackable VLAN network.

2116

VLAN Stacking