Reference Guide

boot system gateway 10.11.93.254
!
service timestamps log datetime
!
logging coredump
!
hostname Dell
! protocol lldp
!
feature extended-bridge
!
redundancy auto-failover-limit count 3 period 60
redundancy auto-synchronize full
redundancy disable-auto-reboot rpm
!
Related
Commands
show running-config – displays the current (running) configuration.
upgrade
Upgrade the bootflash, bootselector, or Dell Networking OS (system) image on the switch CPUs.
C9000 Series
Syntax
upgrade {bootflash—image | bootselector-image| system—image} [all |
linecard [slot-id |all] [pe pe-id {stack-unit unit-number}] | rpm{0|1}
{booted | flash: | ftp: | rpmA:| rpmB:| scp:| tftp: | usbflash:}
Parameters
bootflash-image Enter the keyword bootflash-image to upgrade the bootflash
image on the switch CPUs.
bootselector-
image
Enter the keyword bootselector-image to upgrade the
bootselector image on the switch CPUs. Use this option only with
TAC supervision.
system-image Enter the keyword system-image to upgrade the boot OS image
stored in cache memory of the switch CPUs.
all Enter the keyword all to upgrade the bootflash and bootselector
images on the switch CPUs.
linecard slot-id Enter the keyword linecard and specify the linecard slot-id . The
linecard slot id range is from 0 to 11. Enter linecard all to select all
linecards.
rpm slot-id Enter the keyword rpm to upgrade Control and Route processors of
the RPM . To upgrade standby RPM execute the command from
primary RPM with rpmA: | rpmB:,option.
pe pe-id Enter the keyword pe and specify the port extender ID number. The
PE ID range is from 0 to 255. Enter pe all to upgrade all port
extenders attached to the C9010.
218
File Management