Reference Guide

Reload the system after executing this command.
To upgrade the Dell Networking OS image on a port extender from an attached C1048P
console, enter the upgrade command in EXEC mode.
Examples (upgrade
bootflash-image
all booted)
Dell#upgrade bootflash-image all booted
Current Boot information in the system:
============================================
Card BootFlash Current Version New Version
---------------------------------------------------------------------
rpm 0 (CP) Boot Flash 3.3.1.15 3.3.1.15
rpm 0 (RP) Boot Flash 3.3.1.15 3.3.1.15
Linecard10 Boot Flash 3.3.1.15 3.3.1.15
***********************************************************************
* Warning - Upgrading boot flash is inherently risky and should only
*
* be attempted when necessary. A failure at this upgrade may cause
*
* a board RMA. Proceed with caution !
*
***********************************************************************
Proceed Boot Flash image for all cards [yes/no]: no
Example (upgrade
bootselector-
image all booted)
Dell#upgrade bootselector-image all booted
Current Boot information in the system:
===========================================
Card BootSelector Current Version New Version
--------------------------------------------------------------------
rpm 0 (CP) Boot Selector 3.3.0.0c 3.3.0.0f
rpm 0 (RP) Boot Selector 3.3.0.0c 3.3.0.0f
Linecard10 Boot Selector 3.3.0.0c 3.3.0.0f
***********************************************************************
* Warning - Upgrading boot selectors is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Proceed Boot Selector image for all cards [yes/no]: no
220
File Management