Reference Guide

StartingSeqNum Enter the starting sequence number to resequence. The
range is from 0 to 65535.
Step-to-
Increment
Enter the step to increment the sequence number. The
range is from 1 to 65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale
7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-
assigning a new sequence number to entries of an existing prefix list.
Related
Commands
resequence access-list — resequences an access-list.
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
C9000 Series
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host
ip-address}} [count [bytes]] [dscp value] [order] [fragments]
[log [interval minutes] [threshold-in-msgs [count]] [monitor]
To delete a filter, use the no seq sequence-number command.
264
Access Control Lists (ACL)