Reference Guide

monitored interface. For more information, refer to the
“Flow-based Monitoring” section in the Port Monitoring
chapter of the Dell Networking OS Configuration Guide.
Defaults Not configured
Command Modes CONFIGURATION-STANDARD-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Add the DSCP value for ACL matching.
8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Added support for the non-contiguous mask and added the
monitor option.
6.5.10 Expanded to include the optional QoS order priority for the
ACL entry.
Usage Information
Use the order option only when you use policy-based QoS on the switch. For
more information, refer to the Quality of Service chapter of the C9000 Series
Configuration Guide. The following conditions apply:
• The seq sequence-number command is applicable only in an ACL group.
• The order option works across ACL groups that have been applied on an
interface via the QoS policy framework.
• The order option takes precedence over seq sequence-number.
• If sequence-number is not configured, the rules with the same order value are
ordered according to their configuration order.
• If sequence-number is configured, the sequence-number is used as a tie
breaker for rules with the same order.
266
Access Control Lists (ACL)