Reference Guide

[bytes]] [dscp value] [order] [monitor] [fragments] [log
[interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no deny {ip | ip-protocol-number} {source mask | any |
host ip-address} {destination mask | any | host ip-address}
command.
Parameters
ip Enter the keyword ip to configure a generic IP access list.
The keyword ip specifies that the access list denies all IP
protocols.
ip-protocol-
number
Enter a number from 0 to 255 to deny based on the
protocol identified in the IP protocol header.
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or noncontiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
count (OPTIONAL) Enter the keyword count to count packets that
the filter processes.
bytes (OPTIONAL) Enter the keyword byte to count bytes that the
filter processes.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP
DSCP values. The range is from 0 to 63.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
fragments Enter the keyword fragments to use ACLs to control
packet fragments.
log (OPTIONAL) Enter the keyword log to include ACL matches
in the log.
Access Control Lists (ACL)
269