Reference Guide

NOTE: When ACL logging and byte counters are configured simultaneously,
byte counters may display an incorrect value. Configure packet counters with
logging instead.
permit tcp
To pass TCP packets meeting the filter criteria, configure a filter.
C9000 Series
Syntax
permit tcp {source mask | any | host ip-address} [bit]
[operator port [port]] {destination mask | any | host ip-
address} [bit] [dscp] [operator port [port]] [count [bytes]]
[log] [order] [monitor] [fragments]
To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s
sequence number.
• Use the no permit tcp {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject
to the filter.
host ip-address Enter the keyword host then the IP address to specify a
host IP address.
bit Enter a flag or combination of bits:
• ack: acknowledgement field
• fin: finish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent field
dscp Enter the keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
288
Access Control Lists (ACL)